The research on the dental bridge model-making process based on the curing shrinkage epoxy and residual stress reduction

doi:10.1093/jom/ufab030

中山醫學大學機構典藏 CSMUIR > 中山醫學大學研究成果 > 期刊論文 > Item 310902500/23927

請使用永久網址來引用或連結此文件: https://ir.csmu.edu.tw:8080/ir/handle/310902500/23927

題名:	The research on the dental bridge model-making process based on the curing shrinkage epoxy and residual stress reduction
作者:	Yuan, CCA;Shen, GQ;Huang, YC;Ding, SJ;Yan, M
關鍵詞:	dental bridge;curing shrinkage epoxy;photoelasticity;model-making procedure
日期:	2021
上傳時間:	2022-08-05T09:45:06Z (UTC)
出版者:	OXFORD UNIV PRESS
ISSN:	1727-7191
摘要:	Elderly people suffer from more and more teeth problems. The tooth-implant-supported prosthesis provides a reliable solution to missing teeth patients. The proper dental prosthesis design to prevent overstress is essential due to the mechanical characteristics of the dental bridge abutments are different. The finite element method is widely applied, but proper experimental validation is required. The curing shrinkage epoxy is applied for the photoelasticity measurement because its mechanical property is close to the cancellous bone. A series of process developments, including mold design, residual stress releasing and artificial soft film making, is accomplished in this research to simulate the mechanical response of dental bridges in practice. The process is proven and can be accomplished at the dentist's workshop. The transmission photoelasticity technique is applied to measure the residual stress distribution and it nondestructively provides the continuous improvement guideline. The model-making procedure and tools are proven to be available at the dental workshop. Following the model-making procedure, the dental bridge model shows a low residual stress level that the photoelasticity system cannot detect. Excellent reproducibility of the proposed procedure has been validated. These models exhibit stable maximum stress of 2.13 MPa around the natural tooth apex and apical implant region when a 300 N vertical loading is applied upon the dental bridge. Finally, a finite element model of the dental bridge, including the natural tooth and dental implant, is built and validated by the photoelastic measurement.
URI:	http://dx.doi.org/10.1093/jom/ufab030 https://www.webofscience.com/wos/woscc/full-record/WOS:000770772500001 https://ir.csmu.edu.tw:8080/handle/310902500/23927
關聯:	JOURNAL OF MECHANICS ,2021,v37 , P659-668
顯示於類別:	[中山醫學大學研究成果] 期刊論文

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
index.html		0Kb	HTML	243	檢視/開啟

在CSMUIR中所有的資料項目都受到原著作權保護.

TAIR相關文章

資料載入中.....