Biomechanical analysis of rigid and non-rigid connection with implant abutment designs for tooth-implant supported prosthesis: A finite element analysis

doi:10.1016/j.jds.2021.07.020

中山醫學大學機構典藏 CSMUIR > 中山醫學大學研究成果 > 期刊論文 > Item 310902500/23270

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: https://ir.csmu.edu.tw:8080/ir/handle/310902500/23270

题名:	Biomechanical analysis of rigid and non-rigid connection with implant abutment designs for tooth-implant supported prosthesis: A finite element analysis
作者:	Huang, YC;Ding, SJ;Yuan, CM;Yan, M
关键词:	Biomechanics;Tooth-implant;supported;Finite element;Stress distribution
日期:	2021
上传时间:	2022-08-05T09:34:33Z (UTC)
出版者:	ELSEVIER TAIWAN
ISSN:	1991-7902
摘要:	Background/purpose: The design of the connectors and implant abutments could affect the stress distribution of the tooth-implant supported prosthesis (TISP) entire system after loading. Therefore, the purpose of this study was to investigate the stress distribution of the TISP in different connectors and different implant abutments after loading. Materials and methods: The TISP design used in this study was divided into six models. R1, R2 and R3 represented the tooth and the one-piece, two-piece and three-piece abutment implant system connected by a rigid connector, respectively, while NR1, NR2 and NR3 were the corresponding tooth-abutment implant systems connected by a non-rigid connector. A vertical occlusal load of 50 N was applied at a right angle on the 6 occlusal points of the occlusal surface. Results: As a result, regarding the maximum average stress distribution, R1 and NR1 appeared on the implant fixture, and the other four models were on the implant abutment. On the other hand, regardless of the abutment implant system, the maximum von Mises stress generated by the rigid connector was greater than the corresponding non-rigid connector in the cortical bone around implant. In addition, the three-piece abutment implant system had lower von Mises stress than the one-piece and two-piece implant systems in the cortical bone. Conclusion: It is concluded that by adding a flexible non-rigid connector and three-piece abutment device design to TISP, the occlusal load of the implant was dispersed, and the stress could be gradually introduced into the relatively strong implant abutment. (c) 2021 Association for Dental Sciences of the Republic of China. Publishing services by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons. org/licenses/by-nc-nd/4.0/).
URI:	http://dx.doi.org/10.1016/j.jds.2021.07.020 https://www.webofscience.com/wos/woscc/full-record/WOS:000738511100003 https://ir.csmu.edu.tw:8080/handle/310902500/23270
關聯:	JOURNAL OF DENTAL SCIENCES ,2022,v17,issue 1, P490-499
显示于类别:	[中山醫學大學研究成果] 期刊論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	246	检视/开启

在CSMUIR中所有的数据项都受到原著作权保护.

TAIR相关文章

数据加载中.....